Drywall Installation in North Plainfield, NJ

New drywall hung, taped and finished — ready for primer and paint.

Drywall Installed With the Paint Job in Mind

New drywall shows up most often in basement finishes, additions, and rooms getting gutted back to the studs. The hanging is the visible part, but the finishing — taping every seam and building up joint compound in multiple sanded coats — is what determines whether the wall looks flat and clean under paint or shows every seam once the light hits it. Because Franklin's background is painting, he finishes drywall the way a painter needs it finished, not just "smooth enough" to pass a quick glance.

When You Need Drywall Installation

Finishing a basement or unfinished room
Framing out a home addition that needs interior walls
A room gutted back to the studs for renovation
Replacing plaster walls that are beyond repair
Building a new closet, partition wall, or built-in

How Franklin Installs Drywall

Measure & hang

Panels are measured, cut, and screwed to studs with proper spacing for a stable wall.

Tape the seams

Every joint between panels gets taped so the seam doesn't telegraph through paint later.

Multiple finish coats

Joint compound is applied in progressively wider coats, each sanded smooth once dry.

Final sand & prime

The wall is sanded to a flat, even surface and primed so it's genuinely ready for paint.

What Affects Drywall Installation Cost

Room size and wall count — more square footage and corners means more seams to finish
Ceiling height — vaulted ceilings and stairwells need extra setup
Moisture-resistant board — basements and bathrooms may need specific board types
Finish level — a wall going straight to paint needs a higher finish standard than a garage or storage space

Drywall Installation Around North Plainfield

Franklin installs drywall for basement finishes and additions throughout North Plainfield and Middlesex.

Frequently Asked Questions

Do you handle the taping and finishing, not just hanging panels?

Yes — installation includes hanging the panels, taping every seam, and finishing with joint compound sanded smooth. A wall isn't ready for paint until all three steps are done.

How many finish coats does new drywall need before paint?

Typically three coats of joint compound over the taped seams, each sanded smooth, before the wall is ready for primer. Skipping coats is how seams end up visible under paint.

Can you install drywall in a basement or addition?

Yes, including moisture-resistant board where it's needed, like near a basement's foundation walls or areas prone to humidity.

How long does a room take from bare studs to paint-ready drywall?

A single room typically takes a few days between hanging, taping, and the multiple dry times needed between finish coats — rushing the drying time is what causes seams to crack later.